Legacy Products Archive - Vivax

Loc-10Tx 10-Watt Series Transmitters

October 17, 2017December 17, 2018

The Loc-10Tx broadband transmitter has selectable induction frequencies from 8kHz to 200kHz and direct-connect frequencies from 512Hz to 200kHz. SD (Signal Direction), fault find and true resistance measurement up to 1 Mohm are all standard. The two inch by one-inch backlit dot matrix display shows output current, connection type, volts, resistance, frequency, volume,...

vLocML2+ Receiver

September 21, 2017August 21, 2019

The vLocML2+ Receiver is an extended version of the popular vLocPro2 with the addition of the ability to locate buried electronic markers. The vLocML2+ comes with passive modes of Power and Radio, a range of preloaded active frequencies from 50Hz to 200kHz, Sonde Mode, SD (Signal Direction) mode and Electronic Marker modes. The vLocML2+ has an internal memory to...

vLocDM2 Receiver

September 20, 2017April 5, 2020

The vLocDM2 (Defect Mapper) uses the latest locating and signal processing techniques to plot the current gradient of an industry standard low frequency (3Hz or 4Hz) profiling current. The current is applied at CP stations, so the disruption of the pipeline can be minimized. The non-intrusive measuring device, the vLocDM2 receiver, takes measurements along the...

vLocPro2 (VLP2) Receiver

September 19, 2017December 30, 2020

The vLocPro2 (VLP2) utility locator receiver was designed to meet the tough requirements of the modern world. With more and more utilities being buried each day and also abandoned each day, it truly is a jungle beneath the ground. Today’s locator must not only trace the path of a buried utility, it must assure the...

Spar 300

September 18, 2017November 30, 2022

The Spar 300 family represents a comprehensive approach to surveying and mapping underground utilities. It is fully integrated with the Trimble® Access surveying environment, and operates seamlessly with Trimble® GNSS receivers, may be used with Trimble® Total Stations and is available from many Trimble® dealers. The Spar employs a set of magnetic field sensors...

vLoc2 Accessory A-Frame

August 18, 2017June 26, 2023

The vLoc2 Series Accessory A-Frame accessory is used to detect ground faults on pipes and cables. In the case of pipes, the faults consist of coating defects. In the case of cables, faults are usually caused by insulation damage allowing the metallic sheath (or internal conductor) to become in contact with the ground. It is...